Remote Setipslaveppp - Efficient Networks Router family Command Line Interface Manual

Chapter 6: Remote Commands
Parameters Cont.
multicast
lanconfig
lcpecho
<routername>
a
ASCII string
Response
Command prompt.

remote setipslaveppp

Sets the IP Slave PPP mode. If the slave mode is yes, the router accepts the IP
address that the remote end informs the router that it has; the router disregards any
IP address specified in its own configuration. If the mode is no, the router tries to use
the address in its configuration.
Normally there is no need to change the default (no) value of this option. However, in
certain situations where the router is managed by another party, (as part of a
managed service), you could set this value to yes to ensure that the central
management site always specifies the IP address of the router.
Mgmt Class
Network (R/W)
Input Format
remote setipslaveppp
Parameters
yes | no
<remotename>
a
ASCII string
Response
Command prompt.
Page 6-48
Allows the remote router to forward IP multicast traffic.
Accept LAN configuration information. Indicates that this PPP
remote can receive IPCP information for dynamically recon-
figuring the Ethernet interface.
Use periodic echo.
a
Name of the remote router
yes | no
Slave mode setting. The default is no.
a
Name of the remote router.
Efficient Networks
Command Line Interface Guide
<remotename>
®
Router family
®
Efficient Networks