System Addsnmpfilter - Efficient Networks Router family Command Line Interface Manual

Chapter 4: System Commands

system addsnmpfilter

Validates SNMP clients by defining a range of IP addresses that are allowed to
access the router via SNMP. This validation feature is off by default. This command is
functionally equivalent to the
NOTE:
This command does not require a reboot and is effective immediately.
NOTE:
To list the range of allowed clients, use the
from the SNMP filter, use the
For more information, see
Technical Reference Guide.
Mgmt Class
Security (R/W)
Input Format
system addsnmpfilter <first ip addr> [<last ip addr>] | lan
Parameters
<first ipaddr>
<last ipaddr>
lan
a
Dotted-decimal notation
b
May be omitted if the range contains only one IP address.
Response
Command prompt.
Page 4-12
snmp addsnmpfilter
system delsnmpfilter
"Controlling Remote Management" on page 5-15
a
First IP address of the client range.
a
Last IP address of the client range.
Local Ethernet LAN.
Efficient Networks
Command Line Interface Guide
command.
system list command. To delete addresses
or snmp delsnmpfilter
b
®
Router family
command.
of the
®
Efficient Networks