®
Efficient Networks
Router family
Command Line Interface Guide
Dual-Ethernet Router (ETH) Commands
The following Ethernet commands are used to manage the Ethernet interfaces of the
Dual-Ethernet (Ethernet-to-Ethernet) router and thus are specific to that type of router
only. For the other Ethernet commands, see
Commands.
The Dual-Ethernet router has two interfaces:
•
ETH/0Hub with four 10Base-T connectors
•
ETH/1Single 10Base-T connector
This Dual-Ethernet router may be configured via the Web Browser GUI or from the
Command Line Interface (CLI). To set up any DHCP options and to configure optional
features like IP filtering, you must use the CLI.
If using the Boot from Network option from the boot menu to perform a boot code
update, the boot request is sent from the ETH/0 interface only.
The Dual-Ethernet Router commands found in this section include:
Command
eth br enable
eth br disable
eth br options
®
Efficient Networks
Table 7-4: Dual Ethernet Router Command Listing
Enables bridging in a Dual-Ethernet environment.
Disables bridging in a Dual-Ethernet environment.
Sets controls on bridging for the Ethernet interface.
Chapter 7: WAN Interface Commands
Chapter 5, Ethernet Interface
Function
Page 7-13