Atm Pcr - Efficient Networks Router family Command Line Interface Manual

Chapter 7: WAN Interface Commands

atm pcr

Sets the speed of the ATM link in cells per second.
The default upstream speed is 768 cells/second. Generally, your Network Service
Provider should provide you with your speed value. If your service provider states
your speed value in kilobits per second, enter the value using the
command.
NOTE:
The speed value entered may not be the actual upstream speed attained. When the
command changes the processor clocks, only certain discrete values are allowed.
The speed achieved is the allowed speed value that is equal to or the next lower
value to the value entered (see the example below).
Mgmt Class
Network (R/W)
Input Format
atm pcr [cells/second]
Parameters
***
<cells/second>
a
Integer, 294-18867
Example
The following command requests the current speed.
-> atm pcr 1200
ATM Upstream Rate:
Response
Typical response when entered with no parameter.
-> atm pcr
ATM Upstream Rate:
Page 7-6
When entered with no parameters, the current upstream speed is
displayed.
a
Upstream speed requested in cells/second.
500 Kb/sec or
326 Kb/sec or
Efficient Networks
Command Line Interface Guide
atm speed
1179 cells/sec
768 cells/sec
Efficient Networks
®
Router family
®