Sntp Request - Efficient Networks Router family Command Line Interface Manual

Chapter 2: Status Commands
When entered with a <number> parameter:
-> sntp prefserver 3
Preferred SNTP server is set to 3 (192.6.38.127)

sntp request

Requests the time from an SNTP server. (SNTP is the Simple Network Time Protocol
defined by RFC 1769.)
NOTE:
A request is performed only if SNTP is enabled (see
Mgmt Class
Admin (R/W)
Input Format
sntp request
Parameters
None
Response
When entered while sntp function is currently disabled:
-> sntp request
SNTP is currently disabled
When entered and no sntp preferred server is defined:
-> sntp request
Time server IP address not set, use "sntp server w.x.y.z"
When entered and an sntp preferred server has been defined:
-> sntp request
Time set to UTC-480, 5/7/2001 at 17:29:25.245
Time adjusted for (-) 0 days 1 hours 0 minutes 0 seconds
Page 2-26
®
Efficient Networks Router family
Command Line Interface Guide
sntp enable).
Efficient Networks
®