Remote Delatmsnap; Remote Delbridge - Efficient Networks Router family Command Line Interface Manual

®
Efficient Networks Router family
Command Line Interface Guide

remote delatmsnap

This command deletes an ATM mapping set by the
page 40.
Mgmt Class
Network (R/W)
Input Format
remote delatmfasp
<remotename>
Parameters
atmf
E164
partial
full
a
<nsnap>
a
specified as 40 hex digits or 20 octets (2-digit pairs separated by colons
Response
Command prompt.

remote delbridge

Removes the designation of the remote router entry as the default bridging
destination. (Default bridging destinations are defined using the
command.) To see the bridge settings for a remote entry, use the
command.
To remove a designation as the default bridging destination for a specific MAC
address, specify that address on the command. The entry is then removed from the
bridging table. To see the entries in the bridging table, use the
Mgmt Class
Network (R/W)
Input Format
remote delbridge
®
Efficient Networks
atmf | e164
ATM forum encoding.
ITU E164 encoding.
The MAC address of the router is substituted for octets 2-7 of the NSAP.
No change is made to the specified NSAP.
NSAP
* | <mac_addr>
Chapter 6: Remote Commands
remote setatmnsap
partial | full
remote addbridge
bi list
<remotename>
command,
<nsap>
remote listbridge
command.
Page 6-17