Eth Start - Efficient Networks Router family Command Line Interface Manual

Chapter 5: Ethernet Interface Commands
Mgmt Class
Network (R/W)
Input Format
eth restart <interface>
Parameters
<interface>
a
Integer, 0, 1 or it may be omitted if the router has only 1 Ethernet interface.
b
To specify a logical interface other than logical interface 0, specify both the port number and
the logical interface number (<port #>:<logical #>, for example, 0:1).
Response
Command prompt.

eth start

Starts a stopped logical Ethernet interface. To read about logical Ethernet interfaces,
see "IP Subnets" on page 6-1
A logical Ethernet interface is stopped using the command
immediately restart a logical Ethernet interface, use the command
Mgmt Class
Network (R/W)
Input Format
eth start <interface>
Parameters
<interface>
a
Integer, 0, 1 or it may be omitted if the router has only 1 Ethernet interface.
b
To specify a logical interface other than logical interface 0, specify both the port number and
the logical interface number (<port #>:<logical #>, for example, 0:1).
Response
Command prompt.
Page 5-38
a,b
Logical Ethernet interface.
of the Technical Reference Guide.
a,b
Logical Ethernet interface.
®
Efficient Networks Router family
Command Line Interface Guide
eth stop. To stop and
eth restart.
Efficient Networks
®