Remote Disable; Remote Disauthen - Efficient Networks Router family Command Line Interface Manual

®
Efficient Networks Router family
Command Line Interface Guide

remote disable

Disables the remote. The remote remains disabled even after a reboot. To enable the
remote, the command
NOTE:
You may enter and save information and settings for a disabled remote entry.
However, the remote entry cannot be used until it is enabled.
NOTE:
If the remote is currently active when the remote is disabled, the active session is not
stopped. To stop the active session, use the
Mgmt Class
Network (R/W)
Input Format
remote disable <remotename>
Parameters
<remotename>
a
ASCII string
Response
Command prompt.

remote disauthen

This command is intended for situations where third-party routers cannot be
authenticated; the target router will not attempt to authenticate the remote router.
Mgmt Class
Security (R/W)
Input Format
remote disauthen <remotename>
®
Efficient Networks
remote enable
a
Name of the remote router.
Chapter 6: Remote Commands
must be entered.
remote stop command.
Page 6-25