Telnet Session For Remote Access - Efficient Networks Router family Command Line Interface Manual

®
Efficient Networks Router family
Command Line Interface Guide

Telnet Session for Remote Access

From the local area network you can use TELNET to login in using the Ethernet IP
address. (For more information, see Telnet Remote Access.)
NOTE:
Remote access to the router configuration can be disabled or restricted. For further
information, see
Step 1 Make sure that your PC and router addresses are in the same subnetwork. For
example, the router address could be 192.168.254.254 and the PC address could be
192.168.254.253.
Step 2 Start a TELNET session.
a.If you are using a PC running Windows" 95/98/NT", select Start > Run. If on a
UNIX system, bring up a shell window.
b.In the Run dialog box (or shell) window, enter:
c.Click OK, or press <Enter>.
Step 3 A TELNET window will be launched; a line identifying the router will be displayed,
followed by the Login: prompt as shown below.
Efficient 5950 G.SHDSL [ATM] Router (5950-001)Ready
Username:
®
Efficient Networks
"Controlling Remote Management" on page 5-15.
telnet 192.168.254.254
Task Complete
Chapter 1: Introduction
Page 1-7