Hdsl Terminal - Efficient Networks Router family Command Line Interface Manual

Chapter 7: WAN Interface Commands
Parameters
***
384
1168
b
noauto
a
Available only if the modem has activated successfully.
b
hdsl speed noauto should be followed by the command
and reboots.
Response
Command prompt:

hdsl terminal

The router is by default configured as the Customer Premises Equipment (CPE). Use
this command if you intend to configure the router as the Central Office equipment
(CO).
• hdsl terminal cpe defines the CPE end (default configuration)
• hdsl terminal co defines the CO end.
• hdsl terminal displays the current settings.
Mgmt Class
Network (R/W)
Input Format
hdsl terminal [cpe | co]
Parameters
***
cpe
co
Response
Command example displaying current mode:
-> hdsl terminal
Customer Premise
Page 7-26
When entered with no parameters, the current speed is dispaly-
a
ed.
Authorized non-default speed for the CO in Mbps.
Authorized non-default speed for the CO in Mbps.
Used to override auto-speed on the CPE.
When entered with no parameters, the current mode is displayed.
Sets the terminal operation mode to CPE.
Sets the terminal operation mode to CO.
Efficient Networks
Command Line Interface Guide
hdsl save to be persistent across restarts
Efficient Networks
®
Router family
®