Pppoe Close - Efficient Networks Router family Command Line Interface Manual

Chapter 11: PPPoE Commands
Parameters
<service>
*
-
<remotename>
a
ASCII string
b
Name is case-sensitive
Example
The following commands define the remote router used to connect to the PPPoE
service DialUpPPP.net. Note that the remote setPPPoEservice command is entered
immediately after the remote add command.
-> remote add pppoeremote
-> remote setpppoeservice dialupppp.net pppoeremote
Response
Command prompt.

pppoe close

Closes a currently active PPPoE session. To see the currently active PPPoE
sessions, use the command
Mgmt Class
Security (R/W)
Input Format
pppoe close <ifsnumber>
Parameters
<ifsnumber>
a
Specify the PPPoE/Ifs number for the session as shown in the ifs or
Response
Command prompt.
Page 11-2
a
Name of the PPPoE service to which this remote connects PPPoE
users. The service provider defines the name of its service.
Specify * if the router can be used to connect to any PPPoE service.
Specify - to clear the setting.
a Name of the remote router.
pppoe
Session to be closed.
Efficient Networks
Command Line Interface Guide
list.
a
pppoe list
®
Router family
b
command output.
®
Efficient Networks