Eth Vrrp Delete - Efficient Networks Router family Command Line Interface Manual

Chapter 5: Ethernet Interface Commands

eth vrrp delete

Deletes a VRRP attribute record for the VRID (virtual router ID). It also disassociates
the VRRP IP and MAC addresses from the logical interface. For more information,
see "VRRP Backup" on page 6-16
Use this command to disable VRRP. To re-instate a deleted VRID, you need to
redefine both the VRID and the VRRP attribute record. For example, the following
commands disable VRID 7 and then re-enable it for the logical interface 0:0:
-> eth vrrp delete 7
-> eth ip vrid 7
-> eth vrrp add 7
-> 04/16/2001-08:36:06:VRRP: VRRP 7 on Interface ETHERNET/0 now active
When removing a VRRP configuration from a router, you would delete both the VRRP
attribute record and the extra logical interface. To do so, use the commands
delete and
NOTE:
This command takes effect immediately, but you must
persist after you restart the interface or reboot the router.
Mgmt Class
Network (R/W)
Input Format
eth vrrp delete <vrid> [<port#>]
Parameters
a
<vrid>
b
<port#>
a
Integer, 1 - 255
b
The default is 0; the parameter may be omitted if the router has only one port.
Example
This command example deletes the attribute record for VRID 7 for the default port 0.
-> eth vrrp delete 7
Response
Command prompt.
Page 5-42
eth delete.
Virtual router ID.
Physical Ethernet interface (port) number.
Efficient Networks
Command Line Interface Guide
of the Technical Reference Guide.
save
®
Router family
eth vrrp
the change if it is to
Efficient Networks
®