®
Efficient Networks
Router family
Command Line Interface Guide
idsl set switch
Specifies link speeds of 64, 128, or 144 Kbps for the IDSL connection.
Mgmt Class
Network (R/W)
Input Format
idsl set switch FR64 | FR128 | FR144
Parameters
FR64
FR128
FR144
Response
Command prompt.
remote setdlci
This command sets the DLCI for the remote router entry. The DLCI (Data Link
Connection Identifier) is an address identifying a logical connection in a Frame Relay
environment. The DLCI is generally provided by the Network Service Provider.
The IDSL router can support several DLCI virtual circuits over a Frame-Relay IDSL
link. However, a typical connection to the Internet requires only one DLCI. The DLCI
number must match the DLCI of the remote end.
Mgmt Class
Network (R/W)
Input Format
remote setdlci <dlcinumber> <remotename>
®
Efficient Networks
Link speed of 64 Kbps
Link speed of 128 Kbps
Link speed of 144 Kbps
Chapter 7: WAN Interface Commands
Page 7-29