Configuring Virtual Players (Web Interface); Add Virtual Player; Configure, Show, Or Remove Virtual Players; Figure 44 Virtual Player Page - Juniper MEDIA FLOW CONTROLLER 2.0.4 - ADMINISTRATOR S GUIDE AND CLI Administrator's Manual

Media Flow Controller Administrator's Guide

Configuring Virtual Players (Web Interface)

Create a virtual player and set virtual player options.
To configure virtual players:
•
From the left navigation pane in the Service Config tab, select Virtual Player.
The Virtual Player Configuration page is displayed. See
Figure 44 Virtual Player Page

Add Virtual Player

Add a virtual player and then click Configure in the List of Virtual Players to open a new
window and make configurations. See
•
Virtual Player Name—Name the virtual player; you use this name when adding a virtual
player to a namespace.
•
Virtual Player Type—Choose Type0 (default) for a generic virtual player; this type has
the most configuration options.

Configure, Show, or Remove Virtual Players

Open a configuration window for a new or existing virtual player, or check settings or remove a
virtual player. See
To configure, view settings of, or remove selected virtual players:
1. Click the Configure link for the virtual player you want to remove. A configuration window
opens for that type of virtual player.
2. Click the Show link for the virtual player settings you want to view. A n area is displayed
with that virtual player's settings.
3. Select the checkbox for the virtual player you want to remove. Click Remove Selected.
4. Click Save at the top of the page to make changes persistent across reboots.
Media Flow Controller Configuration Tasks (Web Interface)
Figure
Figure 44.
Figure
44.
Configuring Virtual Players (Web Interface)
44.
167