Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual page 976

Destination Profiles
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Command
Step 5
switch(config-callhome)#
destination-profile XML-destination
email-addr findout@.cisco.com
switch(config-callhome)#
destination-profile XML-destination
message-size 100000
Steps 3, 4, and 5 in this procedure can be skipped or configured in any order.
Note
To configure a new destination-profile (and related parameters), follow these steps:
Command
Step 1
switch# config t
Step 2
switch(config)# callhome
switch(config-callhome)#
Step 3
switch(config-callhome)# destination-profile
test
Step 4
switch(config-callhome)# destination-profile
test email-addr person@place.com
Step 5
switch(config-callhome)# destination-profile
test message-size 1000000
Step 6
switch(config-callhome)# destination-profile
test format full-txt
switch(config-callhome)# destination-profile
test format short-txt
Steps 4, 5, and 6 in this procedure can be skipped or configured in any order.
Note
Cisco MDS 9000 Family Configuration Guide
45-6
Purpose
Configures an e-mail address for the predefined
XML-destination profile. The email-addresses in this
destination-profile receives messages in XML format. This
format provides information that is compatible with Cisco
Systems TAC support.
Do not add a pager-related e-mail address to this
Tip
destination profile because of the large message
size.
Configures maximum destination message size for the
predefined destination profile
range is 0 to 1,000,000 bytes and the default is 500,000. A
value of 0 implies that a message of any size can be sent.
Purpose
Enters configuration mode.
Enters the Call Home submode.
Configures a new destination profile called test.
Configures the e-mail address for the user-defined
destination profile (test) sent in default XML
format.
Configures a maximum message size for the
destination email addresses in the user-defined
destination profile (test) sent in default XML
format. The valid range is 0 to 1,000,000 bytes and
the default is 500,000. A value of 0 implies that a
message of any size can be sent.
Configures message-format for the user-defined
destination profile (test) to be full text format.
Configures message-format for the user-defined
destination profile (test) to be short text format.
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Chapter 45 Configuring Call Home
. The valid
XML-destination