Auto-Topology Configuration - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Example Configurations
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Verify the zone set updates. Upon successful IVR zone set activation, verify that appropriate zones are
Step 13
added to the active zone set. Repeat this step for VSANs 2 and 3.
mds# show zoneset active vsan 1
zoneset name finance_dept vsan 1
zone name accounts_database vsan 1
zone name IVRZ_tape_server1 vsan 1
zone name IVRZ_tape_server2 vsan 1
zone name $default_zone$ vsan 1
mds# show ivr zoneset status
Zoneset Status
______________
status per vsan:
__________________

Auto-Topology Configuration

This section provides example configuration steps for configuring IVR auto-topology supported in Cisco
SAN-OS Release 2.1(1a) and later.
Enable IVR on every border switch in the fabric.
Step 1
switch# config t
Enter configuration commands, one per line.
switch(config)# ivr enable
switch(config)# exit
switch#
Verify that IVR is enabled on every IVR-enabled switch.
Step 2
switch# show ivr
Inter-VSAN Routing is enabled
Inter-VSAN enabled switches
---------------------------
No IVR-enabled VSAN is active. Check VSAN-Topology configuration.
Inter-VSAN topology status
--------------------------
Current Status: Inter-VSAN topology is INACTIVE
Cisco MDS 9000 Family Configuration Guide
18-34
pwwn 10:00:23:11:ed:f6:23:12
pwwn 10:00:56:43:11:56:fe:ee
pwwn 10:02:66:45:00:20:89:04
pwwn 10:02:50:45:32:20:7a:52
pwwn 10:02:50:45:32:20:7a:52
pwwn 10:00:ad:51:78:33:f9:86
name : tape_server1_server2
state : activation success
last activate time : Tue May 20 23:23:01 1980
force option : on
vsan status
____ ______
1 active
Chapter 18 Configuring Inter-VSAN Routing
End with CNTL/Z.
OL-6973-03, Cisco MDS SAN-OS Release 2.x