Command Scheduler Initialization; Job Definition - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Mds 9000 family

Table of Contents

Scheduling Maintenance Jobs

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .

Command Scheduler Initialization

To use the scheduling feature, you must explicitly enable this feature on the required switches in the

fabric. By default, this feature is disabled in all switches in the Cisco MDS 9000 family.

The configuration and verification commands for the command scheduler feature are only available

when this feature is enabled on a switch. When you disable this feature, all related configurations are

automatically discarded.

To enable the command scheduling feature, follow these steps:

switch# config t

switch(config)# scheduler enable

switch(config)# no scheduler enable

To define a job, you must specify the job name. This action places you in the job definition (

submode. In this submode, you can define the sequence of CLI commands that the job has to perform.

Be sure to exit the

You cannot modify or remove a command after entering the sequence of commands. To make changes,

you must explicitly delete the defined job name and restart this process.

You must exit the config-job submode for the job definition to be complete.

OL-6973-03, Cisco MDS SAN-OS Release 2.x

Enters configuration mode.

Enables the scheduler.

Discards the scheduler configuration and disables the

scheduler (default).

submode to complete the job definition.

Scheduler Configuration

Cisco MDS 9000 Family Configuration Guide