Sfp Transmitter Types; Configuring Management Interfaces - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Mds 9000 family

Table of Contents

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .

SFP Transmitter Types

The small form-factor pluggable (SFP) hardware transmitters are identified by their acronyms when

displayed in the show interface brief command. If the related SFP has a Cisco-assigned extended ID,

then the show interface and show interface brief commands display the ID instead of the transmitter

type. The show interface transceiver command and the show interface fcslot/port transceiver

command display both values for Cisco supported SFPs.

command output (see the

Standard transmitters defined in the GBIC specifications

short wave laser

long wave laser

long wave laser cost reduced

Extended transmitters assigned to Cisco-supported SFPs

Configuring Management Interfaces

You can remotely configure the switch through the management interface (mgmt0). To configure a

connection remotely, you must configure the IP parameters (IP address, subnet mask, and default

gateway) from the CLI so that the switch is reachable.

Before you begin to configure the management interface manually, obtain the switch's IP address and IP

subnet mask.

To configure the mgmt0 Ethernet interface, follow these steps:

switch# config terminal

switch(config)#

switch(config)# interface mgmt0

switch(config-if)#

Cisco MDS 9000 Family Configuration Guide

"Displaying Interface Information" section on page

SFP Transmitter Acronym Definitions

defines the acronyms used in the

Enters configuration mode.

Configures the management Ethernet interface on

the switch to configure the management interface.

OL-6973-03, Cisco MDS SAN-OS Release 2.x

Configuring Interfaces