Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual page 129

Chapter 4 Initial Configuration
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
f.
Step 12 Enter yes (yes is the default) to enable Telnet service.
Enable the telnet service? (yes/no) [y]: yes
Enter yes (no is the default) to enable the SSH service.
Step 13
Enabled SSH service? (yes/no) [n]: yes
Enter the SSH key type (see the
Step 14
would like to generate.
Type the SSH key you would like to generate (dsa/rsa/rsa1)? dsa
Enter the number of key bits within the specified range.
Step 15
Enter the number of key bits? (768 to 2048): 768
Enter yes (no is the default) to configure the NTP server.
Step 16
Configure NTP server? (yes/no) [n]: yes
a.
Step 17 Enter shut (shut is the default) to configure the default switchport interface to the shut state.
Configure default switchport interface state (shut/noshut) [shut]: shut
Note
Enter on (on is the default) to configure the switchport trunk mode.
Step 18
Configure default switchport trunk mode (on/off/auto) [on]: on
Enter on (off is the default) to configure the PortChannel auto-create state.
Step 19
Configure default port-channel auto-create state (on/off) [off]: on
Enter permit (deny is the default) to deny a default zone policy configuration.
Step 20
Configure default zone policy (permit/deny) [deny]: permit
Permits traffic flow to all members of the default zone.
Step 21 Enter yes (no is the default) to enable a full zone set distribution (see the
on page
Enable full zoneset distribution (yes/no) [n]: yes
Overrides the switch-wide default for the full zone set distribution feature.
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Enter the DNS IP address.
DNS IP address: name_server
Enter yes (default is no) to configure the default domain name.
Configure the default domain name? (yes/no) [n]: yes
Enter the default domain name.
Default domain name: domain_name
Enter the NTP server IP address.
NTP server IP address: ntp_server_IP_address
The management ethernet interface is not shut down at this point—only the Fibre Channel,
iSCSI, FCIP, and Gigabit Ethernet interfaces are shut down.
19-11).
"Generating the SSH Server Key Pair" section on page
Cisco MDS 9000 Family Configuration Guide
Initial Setup Routine
26-14) that you
"Zone Set Distribution" section
4-9