Table of Contents
Advertisement
Configuring Fibre Channel Routes
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
To configure the FSPF retransmit time interval, follow these steps:
Command
Step 1
switch# config t
Step 2
switch(config)# interface fc1/4
switch(config-if)#
Step 3
switch(config-if)# fspf retransmit-interval
15 vsan 12
switch(config-if)#
Configuring Fibre Channel Routes
Each port implements forwarding logic, which forwards frames based on its FC ID. To configure the FC
ID for the specified interface and domain, you can configure the specified route (for example FC ID
111211 and domain ID 3) in the switch with domain ID 1 (see
Figure 21-4
Domain ID 1
Other than in VSANs, run-time checks are not performed on configured and suspended static routes.
Note
Cisco MDS 9000 Family Configuration Guide
21-8
Fibre Channel Routes
fc1/1
Domain ID 3
FC ID 111211
Chapter 21
Configuring Fibre Channel Routing Services and Protocols
Purpose
Enters configuration mode.
Configures the specified interface, or if already
configured, enters configuration mode for the
specified interface.
Specifies the retransmit time interval for
unacknowledged link state updates in VSAN
12. The default is 5 seconds.
Figure
Domain ID 7
OL-6973-03, Cisco MDS SAN-OS Release 2.x
21-4).
Advertisement
Table of Contents
