Table of Contents
Advertisement
Chapter 2
Before You Begin
About the Switch Prompt
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
About the Switch Prompt
Refer to the Cisco MDS 9200 Series Hardware Installation Guide or the Cisco MDS 9500 Series
Note
Hardware Installation Guide for installation and connection instructions.
Once the switch is powered on successfully, you see the default switch prompt (
) as shown in
switch#
Example
2-1.
Example 2-1
Output When Switch Boots Up
Auto booting bootflash:/boot-279 bootflash:/system_image;...
Booting kickstart image:bootflash:/boot-279....
............................................Image verification OK
Starting kernel...
INIT: version 2.78 booting
Checking all filesystems..... done.
Loading system software
Uncompressing system image: bootflash:/system_image
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
INIT: Entering runlevel: 3
<<<<<<SAN OS bootup log messages>>>>>>
---- Basic System Configuration Dialog ----
This setup utility will guide you through the basic configuration of
the system. Use ctrl-c to abort configuration dialog at any prompt.
Basic management setup configures only enough connectivity for
management of the system.
Would you like to enter the basic configuration dialog (yes/no): yes
<<<<<<after configuration>>>>>>
switch login:admin101
Password:*******
Cisco Storage Area Networking Operating System (SAN-OS) Software
TAC support: http://www.cisco.com/tac
Copyright (c) 2002-2004, Cisco Systems, Inc. All rights reserved.
The copyrights to certain works contained herein are owned by
Cisco Systems, Inc. and/or other third parties and are used and
distributed under license. Some parts of this software are covered
under the GNU Public License. A copy of the license is available
at http://www.gnu.org/licenses/gpl.html.
switch#
You can perform embedded CLI operations, access command history, and use command parsing
functions at this prompt. The switch gathers the command string upon detecting an Enter (CR) and
accepts commands from a terminal.
Cisco MDS 9000 Family Configuration Guide
2-2
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Advertisement
Table of Contents
Need help?
Do you have a question about the DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor and is the answer not in the manual?
Questions and answers