Table of Contents
Advertisement
Chapter 26
Configuring Users and Common Roles
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Caution
Log in to the switch using the new administrator password.
Step 8
switch login: admin
Password: <new password>
Reset the new password to ensure that is it is also the SNMP password for Fabric Manager.
Step 9
switch# config t
switch(config)# username admin password <new password>
switch(config)# exit
switch#
Save the software configuration.
Step 10
switch# copy running-config startup-config
Insert the previously removed supervisor module into slot 6 in the chassis.
Step 11
Default Settings
Table 26-2
Table 26-2
Parameters
Roles in Cisco MDS Switches
VSAN policy for roles
User account
Password
Accounting log size
SSH service
Telnet service
OL-6973-03, Cisco MDS SAN-OS Release 2.x
If you boot a system image that is older than the image you used to store the configuration and
do not use the install all command to boot the system, the switch erases the binary
configuration and uses the ASCII configuration. When this occurs, you must use the init
system command to recover your password.
lists the default settings for all switch security features in any switch.
Default Switch Security Settings
Default
Network operator (network-operator).
Permit.
No expiry (unless configured).
None.
250 KB.
Disabled.
Enabled.
Cisco MDS 9000 Family Configuration Guide
Default Settings
26-19
Advertisement
Table of Contents
