Reloading Modules; Reloading The Switch; Power Cycling Modules; Reloading Switching Modules - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Chapter 10 Managing Modules
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .

Reloading Modules

You can reload the entire switch, reset specific modules in the switch, or reload the image on specific
modules in the switch.

Reloading the Switch

To reload the switch, issue the reload command without any options. When you issue this command,
you reboot the switch (see
If you need to issue the reload command, be sure to save the running configuration using the copy
Note
running-config startup-config command.

Power Cycling Modules

To power cycle any module, follow these steps:
Identify the module that needs to be reset.
Step 1
Issue the reload module command to reset the identified module. This command merely power cycles
Step 2
the selected module.
switch# reload module number
Where number indicates the slot in which the identified module resides. For example:
switch# reload module 2
Caution

Reloading Switching Modules

Switching modules automatically download their images from the supervisor module and do not need a
forced download. This procedure is provided for reference should a need arise.
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Chapter 6, "Software
Reloading a module disrupts traffic through the module.
Images").
Cisco MDS 9000 Family Configuration Guide
Reloading Modules
10-7