Table of Contents
Advertisement
Chapter 2
Before You Begin
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
ivr
kernel
line
logging
mcast
nasb
no
ntp
port-security
port-track
power
poweroff
qos
radius
radius-server
rib
rmon
role
rscn
san-ext-tuner
santap
scheduler
scsi-flow
snmp-server
span
ssh
ssm
switchname
system
tacacs+
telnet
tlport
trunk
username
vsan
wwn
zone
zone-attribute-group
zoneset
Configuration mode, also known as terminal configuration mode, has several submodes. Each of these
submodes places you deeper in the prompt hierarchy. When you type exit, the switch backs out one level
and returns you to the previous level. When you type end, the switch backs out to the user EXEC level.
You can also type Ctrl-Z in configuration mode as an alternative to typing end.
In configuration mode, you can alternatively enter
Note
— Ctrl-Z instead of the end command, and
— Ctrl-G instead of the exit command
You can execute an EXEC mode command from a configuration mode or submode prompt. You can issue
this command from any submode within the configuration mode. When in configuration mode (or in any
submode), enter the do command along with the required EXEC mode command. The entered command
is executed at the EXEC level and the prompt resumes its current mode level.
switch(config)# do terminal session-timeout 0
switch(config)#
In this example, terminal session-timeout is an EXEC mode command—you are issuing an EXEC
mode command using the configuration mode do command.
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Config commands for IVR
Kernel options
Configure a terminal line
Modify message logging facilities
Configure multicast
Configure Third-Party Copy Functionality
Negate a command or set its defaults
NTP Configuration
Configure Port Security
Configure Switch port track config
Configure power supply
Poweroff a module in the switch
QoS Configuration commands
Configure RADIUS configuration distribution
Configure RADIUS related parameters
Configure RIB parameters
Remote Monitoring
Configure roles
Config commands for RSCN
Enable/Disable San Extension Tuner tool
Enter SanTap configuration
Config commands for scheduler
SCSI Flow configuration
Configure snmp server
Enter SPAN configuration mode
Configure SSH parameters
Config commands for SSM (Storage Services Module)
Configure system's network name
System config command
Enable tacacs+
Enable telnet
Configure TL Port information
Configure Switch wide trunk protocol
Configure user information.
Enter the vsan configuration mode
Set secondary base MAC addr and range for additional WWNs
Zone configuration commands
Zone attribute group commands
Zoneset configuration commands
CLI Command Hierarchy
Cisco MDS 9000 Family Configuration Guide
2-7
Advertisement
Table of Contents
