Table of Contents
Advertisement
Configuring Gigabit Ethernet Interfaces
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
VRRP for iSCSI and FCIP Services
VRRP provides a redundant alternate path to the Gigabit Ethernet port for iSCSI and FCIP services.
VRRP provides IP address fail over protection to an alternate Gigabit Ethernet interface so the IP address
is always available (see
Figure 37-4 VRRP Scenario
IPS module
IPS module
In
Figure
members can be one or more of the following interfaces:
•
•
•
•
•
See the
Configuring VRRP for Gigabit Ethernet Interfaces
To configure VRRP for Gigabit Ethernet interfaces, follow these steps:
Command
Step 1
switch1# config terminal
switch1(config)#
Step 2
switch(config)# interface
gigabitethernet 2/2
switch(config-if)#
Step 3
switch(config-if)# ip address
10.1.1.10 255.255.255.0
Cisco MDS 9000 Family Configuration Guide
37-16
Figure
Switch 1
10.1.1.10
VRRP master
10.1.1.30
VRRP backup
Switch 2
37-4, all members of the VRRP group must be IP storage Gigabit Ethernet ports. VRRP group
One or more interfaces in the same IPS module or MPS-14/2 module
Interfaces across IPS modules or MPS-14/2 modules in one switch
Interfaces across IPS modules or MPS-14/2 modules in different switches
Gigabit Ethernet subinterfaces
Ethernet PortChannels and PortChannel subinterfaces
"The Virtual Router Redundancy Protocol" section on page
37-4).
VRRP group
virtual IP 10.1.1.100
L2 switch
Purpose
Enters configuration mode.
Enters the interface configuration mode on the Gigabit
Ethernet interface (slot 2, port 2).
Enters the IP address (10.1.1.10) and IP mask
(255.255.255.0) for the Gigabit Ethernet interface.
Chapter 37
Configuring IP Storage
Connect to
10.1.1.100
IP network
36-16.
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Advertisement
Table of Contents
