Table of Contents
Advertisement
Chapter 12
Configuring Trunking
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Displaying Trunking Information
The show interface command is invoked from the EXEC mode and displays trunking configurations for
a TE port. Without any arguments, this command displays the information for all of the configured
interfaces in the switch. See Examples
Example 12-1 Displays a Trunked Fibre Channel Interface
switch# show interface fc1/13
fc1/13 is trunking
Example 12-2 Displays the Trunking Protocol
switch# show trunk protocol
Trunk protocol is enabled
Example 12-3 Displays Per VSAN Information on Trunk Ports
switch# show interface trunk vsan 1-1000
fc3/1 is not trunking
...
fc3/7 is trunking
...
fc3/10 is trunking
fc3/11 is trunking
...
port-channel 6 is trunking
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Hardware is Fibre Channel
Port WWN is 20:0d:00:05:30:00:58:1e
Peer port WWN is 20:0d:00:05:30:00:59:1e
Admin port mode is auto, trunk mode is on
Port mode is TE
Port vsan is 1
Speed is 2 Gbps
Receive B2B Credit is 255
Beacon is turned off
Trunk vsans (admin allowed and active) (1)
Trunk vsans (up)
Trunk vsans (isolated)
Trunk vsans (initializing)
5 minutes input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
5 minutes output rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
233996 frames input, 14154208 bytes, 0 discards
0 CRC, 0 unknown class
0 too long, 0 too short
236 frames output, 13818044 bytes, 0 discards
11 input OLS, 12 LRR, 10 NOS, 28 loop inits
34 output OLS, 19 LRR, 17 NOS, 12 loop inits
Vsan 1000 is down (Isolation due to vsan not configured on peer)
Vsan 1 is up, FCID is 0x760001
Vsan 2 is up, FCID is 0x6f0001
Belongs to port-channel 6
Vsan 1 is up, FCID is 0xef0000
Vsan 2 is up, FCID is 0xef0000
Vsan 1 is up, FCID is 0xef0000
Vsan 2 is up, FCID is 0xef0000
12-1
to 12-3.
(1)
()
()
Cisco MDS 9000 Family Configuration Guide
Displaying Trunking Information
12-7
Advertisement
Table of Contents
