Table of Contents
Advertisement
Chapter 4
Initial Configuration
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Enter yes (no is the default) to create additional accounts.
Step 5
Create another login account (yes/no) [n]: yes
While configuring your initial setup, you can create an additional user account (in the network-admin
role) besides the administrator's account. See the
information on default roles and permissions.
Note
a.
b.
Step 6
Enter yes (yes is the default) to create an SNMPv3 account.
Configure SNMPv3 Management parameters (yes/no) [y]: yes
a.
b.
Note
Enter yes (no is the default) to configure the read-only or read-write SNMP community string.
Step 7
Configure read-only SNMP community string (yes/no) [n]: yes
a.
Enter a name for the switch.
Step 8
Note
Enter the switch name: switch_name
Step 9
Enter yes (yes is the default) to configure out-of-band management.
Continue with Out-of-band (mgmt0) management configuration? [yes/no]: yes
a.
OL-6973-03, Cisco MDS SAN-OS Release 2.x
User login IDs must contain non-numeric characters.
Enter the user login ID.
Enter the user login ID: user_name
Enter the user password.
Enter the password for user_name: user-password
Enter the user name (admin is the default).
SNMPv3 user name [admin]: admin
Enter the SNMPv3 password (minimum of eight characters). The default is admin123.
SNMPv3 user authentication password: admin_pass
By default, if the admin password is at least eight characters, then the SNMP authentication
password is the same as the admin password (at least eight characters). If the admin password is
less than eight characters, then you need to provide a new password for SNMP.
The admin password can have a minimum of one character, but the SNMP authentication
password must have a minimum of eight characters.
Enter the SNMP community string.
SNMP community string: snmp_community
The switch name is limited to 32 alphanumeric characters. The default is switch.
Enter the mgmt0 IP address.
Mgmt0 IP address: ip_address
"Role-Based Authorization" section on page 26-1
Cisco MDS 9000 Family Configuration Guide
Initial Setup Routine
for
4-7
Advertisement
Table of Contents
