Displaying Vty Sessions; Clearing Vty Sessions; Setting The Terminal Timeout - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Chapter 2 Before You Begin
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .

Displaying VTY Sessions

Use the show line command to display all configured VTY sessions:
switch# show line
line Console:
line Aux:

Clearing VTY Sessions

Use the clear line command to close a specified VTY session:
switch# clear line Aux

Setting the Terminal Timeout

Use the terminal session-timeout command in EXEC mode to configure the automatic logout time for
the current terminal session on that switch. When the time limit configured by this command is exceeded,
the switch closes that session and exits.
The syntax for this command from is terminal session-timeout minutes.
The default is 30 minutes. You can set the terminal session-timeout value to 0 to disable this feature so
the terminal remains active until you choose to exit the switch. This change is not saved in the
configuration file.
switch# terminal session-timeout 600
Specifies the terminal timeout to be 600 minutes for the current session.
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Speed: 9600 bauds
Databits: 8 bits per byte
Stopbits: 1 bit(s)
Parity: none
Modem In: Disable
Modem Init-String -
default : ATE0Q1&D2&C1S0=1\015
Statistics: tx:5558511
Speed: 9600 bauds
Databits: 8 bits per byte
Stopbits: 1 bit(s)
Parity: none
Modem In: Disable
Modem Init-String -
default : ATE0Q1&D2&C1S0=1\015
Hardware Flowcontrol: ON
Statistics: tx:35
rx:5033958 Register Bits:RTS|CTS|DTR|DSR|CD|RI
rx:0 Register Bits:RTS|DTR
Cisco MDS 9000 Family Configuration Guide
CLI Command Navigation
2-17