Configuring Ivr Topology Automatic Mode - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Chapter 18 Configuring Inter-VSAN Routing
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
To activate a manually configured IVR topology, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# ivr vsan-topology activate
View your active IVR topology using the show ivr vsan-topology command.
switch# show ivr vsan-topology
AFID
--------------------------------------------------------------
1
1
1
Total:
Current Status: Inter-VSAN topology is ACTIVE
Last activation time: Mon Mar 24 07:19:53 1980

Configuring IVR Topology Automatic Mode

As of Cisco MDS SAN-OS Release 2.1(1a), you can configure IVR topology automatic mode.
IVR configuration distribution must be enabled before configuring IVR topology automatic mode (see
Note
the
enabled, you cannot disable IVR configuration distribution.
To configure IVR topology automatic mode, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# ivr vsan-topology auto
switch(config)# ivr vsan-topology activate
View automatically discovered IVR topology using the show ivr vsan-topology command.
switch# show ivr vsan-topology
AFID
--------------------------------------------------------------
1
1
1
Total:
Current Status: Inter-VSAN topology is AUTO
Last activation time: Mon Mar 24 07:19:53 1980
OL-6973-03, Cisco MDS SAN-OS Release 2.x
SWITCH WWN
20:00:00:05:30:01:1b:c2 *
20:02:00:44:22:00:4a:05
20:02:00:44:22:00:4a:07
3 entries in active and configured IVR VSAN-Topology
"IVR Configuration Distribution" section on page
SWITCH WWN
20:00:00:05:30:01:1b:c2 *
20:02:00:44:22:00:4a:05
20:02:00:44:22:00:4a:07
3 entries in active and configured IVR VSAN-Topology
Purpose
Enters configuration mode.
Activates the configured IVR topology.
Active Cfg. VSANS
yes yes 1-2
yes yes 1-2,6
yes yes 2-5
18-6). Once IVR topology automatic mode is
Purpose
Enters configuration mode.
Configures IVR topology automatic mode.
Disables IVR topology automatic mode and reverts
to user-configuration mode.
Active Cfg. VSANS
yes yes 1-2
yes yes 1-2,6
yes yes 2-5
Cisco MDS 9000 Family Configuration Guide
Configuring IVR Topologies
18-13