Destination Profiles - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Destination Profiles

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Command
Step 4
switch(config-callhome)# email-contact
username@company.com
Step 5
switch(config-callhome)# phone-contact
+1-800-123-4567
Step 6
switch(config-callhome)# streetaddress 1234
Picaboo Street, Any city, Any state, 12345
Step 7
switch(config-callhome)# switch-priority 0
Step 8
switch(config-callhome)# customer-id
Customer1234
Step 9
switch(config-callhome)# site-id
Site1ManhattanNY
Step 10
switch(config-callhome)# contract-id
Company1234
Destination Profiles
A destination profile contains the required delivery information for an alert notification. Destination
profiles are typically configured by the network administrator. At least one destination profile is
required. You can configure multiple destination profiles of one or more types.
You can use one of the predefined destination profiles or define a desired profile. If you define a new
profile, you must assign a profile name.
Cisco MDS 9000 Family Configuration Guide
45-4
Chapter 45
Purpose
Assigns the customer's e-mail address. Up to 128
alphanumeric characters are accepted in e-mail
address format.
Note You can use any valid e-mail address.
You cannot use spaces.
Assigns the customer's phone number. Up to 20
alphanumeric characters are accepted in
international format.
Note You cannot use spaces. Be sure to use the
+ prefix before the number.
Assigns the customer's street address where the
equipment is located. Up to 256 alphanumeric
characters are accepted in free format.
Assigns the switch priority, with 0 being the
highest priority and 7 the lowest.
Use this field to create a hierarchical
Tip
management structure.
Optional. Identifies the customer ID. Up to 256
alphanumeric characters are accepted in free
format.
Optional. Identifies the customer site ID. Up to
256 alphanumeric characters are accepted in free
format.
Assigns the customer ID for the switch. Up to 64
alphanumeric characters are accepted in free
format.
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Configuring Call Home