Nasb Target Rediscovery; Displaying Nasb Information - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

NASB Target Rediscovery

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Command
Step 4
switch(config)# nasb module 4 vsan 10
switch(config)# nasb module 4 vsan 10 control
switch(config)# nasb module 4 vsan 10 multiple
switch(config)# nasb module 4 vsan 10 control
multiple
switch(config)# nasb module 4 vsan 10 multiple
control
Step 5
switch(config)# no nasb module 4 vsan 10
You cannot simultaneously configure the intelligent services SANTap and NASB on a single SSM.
Note
NASB Target Rediscovery
You can initiate a rediscovery of a target device (disk or tape) if the configuration on the target side has
changed without generating an RSCN in the fabric, such as a change in the access list or LUN-mapping
on the target. Use the following step to initiate target device rediscovery:
Command
Step 1
switch# nasb rediscover module 2 vsan 9
target-pwwn 20:02:00:a0:b8:16:a1:5f
nasb rediscovery initiated

Displaying NASB Information

Cisco MDS 9000 Family Configuration Guide
41-4
Chapter 41
Purpose
Enables NASB on the SSM in slot 4 and on
VSAN 10 for a single target LUN. By default,
the LUN is a Direct Access Device (Peripheral
Device Type = 0x00).
Enables NASB on the SSM in slot 4 and on
VSAN 10 for a single target LUN that is a
Storage Array Controller (Peripheral Device
Type = 0x0C).
Enables NASB on the SSM in slot 4 and on
VSAN 10 for up to 10 target LUNs that are
Direct Access Devices (Peripheral Device
Type = 0x00).
The multiple option is supported in
Note
Cisco SAN-OS Release 2.1(2) and
later.
Use the multiple option for
Note
multi-streaming (multiple backup
sessions) on a single virtual target for
Veritas NetBackup.
Enables NASB on the SSM in slot 4 and on
VSAN 10 for Storage Array Controller
(Peripheral Device Type = 0x0C) and up to 10
target LUNs.
Enables NASB on the SSM in slot 4 and on
VSAN 10 for up to 10 target LUNs and
Storage Array Controller (Peripheral Device
Type = 0x0C).
Disables NASB.
Purpose
Initiates a rediscovery of a target device for
the SSM in slot 2.
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Configuring NASB