Default Settings - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Default Settings

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Example 35-42 Displays the Import Target Settings for All Switches
switch# show isns iscsi global config all
iSCSI Global configuration:
Switch: 20:00:44:0d:ec:01:02:40 iSCSI Auto Import: Enabled
Use the show cfs peers command to display CFS peers switch information about the iSNS application
(see
Example 35-43 Displays the CFS Peer Switch Information for the iSNS Application
switch# show cfs peers name isns
Scope
--------------------------------------------------
Switch WWN
--------------------------------------------------
20:00:00:00:ec:01:00:40
Total number of entries = 1
Default Settings
Table 35-2
Table 35-2 Default iSCSI Parameters
Parameters
Number of TCP connections
minimum-retransmit-time
keepalive-timeout
max-retransmissions
PMTU discovery
pmtu-enable reset-timeout
SACK
max-bandwidth
min-available-bandwidth
round-trip-time
Buffer size
Control TCP and data connection
TCP congestion window monitoring
Burst size
Jitter
TCP connection mode
Fibre Channel targets to iSCSI
Cisco MDS 9000 Family Configuration Guide
35-72
Example 35-43).
: Physical
IP Address
10.10.100.11
lists the default settings for iSCSI parameters.
[Local]
Default
One per iSCSI session.
300 ms.
60 seconds.
4 retransmissions.
Enabled.
3600 seconds.
Enabled.
1G.bps
70 Mbps.
1 ms.
4096 KB.
No packets are transmitted.
Enabled.
50KB.
500 Microseconds.
Active mode is enabled.
Not imported.
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Chapter 35 Configuring iSCSI