Enabling Full Zone Set Distribution; One-Time Distribution - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Mds 9000 family
Table of Contents

Advertisement

Zone Set Distribution
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Table 19-1
zoneset distribute vsan Command
(EXEC Mode)
Distributes the full zone set immediately.
Does not distribute the full zone set information
along with the active zone set during activation,
deactivation, or merge process.

Enabling Full Zone Set Distribution

All switches in the Cisco MDS 9000 Family distribute active zone sets when new E port links come up
or when a new zone set is activated in a VSAN. The zone set distribution takes effect while sending
merge requests to the adjacent switch or while activating a zone set.
To enable full zone set and active zone set distribution to all switches on a per VSAN basis, follow these
steps:
Command
Step 1
switch# config t
Step 2
switch(config)# zoneset distribute full vsan 33

One-Time Distribution

You can perform a one-time distribution of inactive, unmodified zone sets throughout the fabric.
Use the zoneset distribute vsan vsan-id command in EXEC mode to perform this distribution.
switch# zoneset distribute vsan 2
Zoneset distribution initiated. check zone status
This command only distributes the full zone set information—it does not save the information to the
startup configuration. You must explicitly issue the copy running start command to save the full zone
set information to the startup configuration.
The zoneset distribute vsan vsan-id command is supported in interop 2 and interop 3 modes—not in
Note
interop 1 mode.
Cisco MDS 9000 Family Configuration Guide
19-12
zoneset distribution Command Differences
Chapter 19
Configuring and Managing Zones
zoneset distribute full vsan Command
(Configuration Mode)
Does not distribute the full zone set immediately.
Remembers to distribute the full zone set
information along with the active zone set during
activation, deactivation, and merge processes.
Purpose
Enters configuration mode.
Enables sending a full zone set along with an
active zone set.
OL-6973-03, Cisco MDS SAN-OS Release 2.x

Advertisement

Table of Contents
loading

Table of Contents