Job Deletion - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Scheduler Configuration
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
To define a job for the command scheduler, follow these steps:
Command
Step 1
switch# conf t
switch(config)#
Step 2
switch(config)# scheduler job name addMemVsan99
switch(config-job)#
Step 3
switch(config-job)# config terminal
switch(config-job-config)# vsan database
switch(config-job-config-vsan-db)# vsan 99 interface
fc1/1 - 4
switch(config-job-config-vsan-db)# end
switch#
switch(config)# scheduler job name offpeakQOS
switch(config-job)# conf t
switch(config-job-config)# qos class-map
offpeakbackupcmap match-all
switch(config-job-config-cmap)# match source-wwn
23:15:00:05:30:00:2a:1f
switch(config-job-config-cmap)# match destination-wwn
20:01:00:05:30:00:28:df
switch(config-job-config-cmap)# exit
switch(config-job-config)# qos policy-map
offpeakbackuppolicy
switch(config-job-config-pmap)# class
offpeakbackupcmap
switch(config-job-config-pmap-c)# priority high
switch(config-job-config-pmap-c)# exit
switch(config-job-config-pmap)# exit
switch(config-job-config)# qos service policy
offpeakbackuppolicy vsan 1
switch(config-job-config)# end
switch#

Job Deletion

To delete a job for the command scheduler, follow these steps:
Command
Step 1
switch# conf t
switch(config)#
Step 2
switch(config)# no scheduler job name addMemVsan99
Cisco MDS 9000 Family Configuration Guide
15-4
Chapter 15 Scheduling Maintenance Jobs
Purpose
Enters the configuration mode.
Defines a job name and enters the job
definition submode
Specifies a sequence of actions for the
specified job. The defined commands
are checked for validity and stored for
future use.
Be sure you exit the
Note
submode.
config-job
Provides another example of
scheduling a different set of jobs.
Purpose
Enters the configuration mode.
Deletes a defined job and all commands
defined within that job.
OL-6973-03, Cisco MDS SAN-OS Release 2.x