Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual page 431

Chapter 18 Configuring Inter-VSAN Routing
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Inter-VSAN zoneset status
-------------------------
Fabric distribution status
-----------------------
fabric distribution disabled
Last Action
Last Action Result
Last Action Failure Reason : None
Inter-VSAN NAT mode status
--------------------------
FCID-NAT is disabled
License status
-----------------
IVR is running based on the following license(s)
ENTERPRISE_PKG
Enable CFS distribution on every IVR-enabled switch in the fabric.
Step 3
switch# config t
Enter configuration commands, one per line.
switch(config)# ivr distribution
Enable IVR auto-topology mode.
Step 4
switch(config)# ivr vsan-topology auto
fabric is locked for configuration. Please commit after configuration is done.
Commit the change to the fabric.
Step 5
switch(config)# ivr commit
switch(config)# exit
switch#
Verify the status of the commit request.
Step 6
switch# show ivr session status
Last Action
Last Action Result
Last Action Failure Reason : None
Verify the active IVR topology.
Step 7
switch# show ivr vsan-topology active
AFID
--------------------------------------------------------------
1
1
OL-6973-03, Cisco MDS SAN-OS Release 2.x
name :
state : idle
last activate time :
SWITCH WWN
20:00:00:0d:ec:08:6e:40 *
20:00:00:0d:ec:0c:99:40
: None
: None
End with CNTL/Z.
: Commit
: Success
Active Cfg. VSANS
yes no 1,336-338
yes no 336,339
Cisco MDS 9000 Family Configuration Guide
Example Configurations
18-35