Automated Upgrades; Benefits Of Using The Install All Command - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Chapter 6 Software Images
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
To view the results of a dynamic compatibility check, issue the show incompatibility system
bootflash:filename command (see
the install all command returns the following message:
Warning: The startup config contains commands not supported by the standby supervisor; as
a result, some resources might become unavailable after a switchover.
Do you wish to continue? (y/ n) [y]: n
Example 6-1
switch# show incompatibility system bootflash:new-image
The following configurations on active are incompatible with the system image
1) Feature Index : 67 , Capability : CAP_FEATURE_SPAN_FC_TUNNEL_CFG
Description : SPAN - Remote SPAN feature using fc-tunnels
Capability requirement : STRICT
2) Feature Index : 119 , Capability : CAP_FEATURE_FC_TUNNEL_CFG
Description : fc-tunnel is enabled
Capability requirement : STRICT

Automated Upgrades

The install all command upgrades all modules in any Cisco MDS 9000 Family switch.
provides an overview of the switch status before and after issuing the install all command.
Figure 6-1
install all
1.2(1a) to 1.3(1)
The install all command automatically verifies if the standby supervisor module is functioning (if
present). If it is not functioning, it reloads that module and uses the reload module slot force-dnld
command to force it to function.

Benefits of Using the install all Command

The install all command provides the following benefits:
•
•
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Displays HA Compatibility Status
The Effect of the install all Command
Switch before issuing
the install all comand
Slot 5
Active
supervisor
module
1.2(1a)
You can upgrade the entire switch using just one command.
You can receive descriptive information on the intended changes to your system before you continue
with the command.
Example 6-1). Use this command to obtain further information when
Cisco MDS 9500 Series switch
Slot 6
Standby
supervisor
module
1.2(1a)
Cisco MDS 9000 Family Configuration Guide
Automated Upgrades
Figure 6-1
Switch after the install all
comand completes
Slot 5 Slot 6
Standby Active
supervisor supervisor
module module
1.3(1) 1.3(1)
6-5