Table of Contents
Advertisement
Chapter 36
Configuring IP Services
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
In
Figure
cannot span across different types of interfaces. In both switch 1 and switch 2, the Ethernet interface is
in VR 1 and the FC interface is in VR 2. Each virtual router is uniquely identified by the VSAN interface
and the VR ID.
Figure 36-7
Link 5
Redundant Gateway
Virtual Router Addition and Deletion
All VRRP configurations should be replicated across switches in a fabric that runs VRRP.
To create or remove a VR, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# interface vsan 1
switch(config-if)#
Step 3
switch(config-if)# vrrp 250
switch(config-if-vrrp)
switch(config-if-vrrp)# no vrrp 250
switch(config-if)
OL-6973-03, Cisco MDS SAN-OS Release 2.x
36-7, the fabric example has two virtual router groups (VR1 and VR 2) because a virtual router
Redundant Gateway
Management
appliance
IP
network
Switch 1
VR1
VR2
Switch 2
Switch 3
IP links
FC links
Virtual Router with
unique VR IP and
VR MAC
Switch 5
Switch 4
FC Fabric
Purpose
Enters configuration mode.
Configures a VSAN interface (VSAN 1).
Creates a VR ID 250.
Removes a VR ID 250.
Cisco MDS 9000 Family Configuration Guide
The Virtual Router Redundancy Protocol
36-17
Advertisement
Table of Contents
