Default Settings - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Default Settings

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Access switch9 and issue the following commands.
Step 7
switch9# show dpvm database active
pwwn 21:00:00:e0:8b:0e:87:8a vsan 1
pwwn 21:01:00:e0:8b:2e:74:8a vsan 1
pwwn 21:00:00:e0:8b:0e:76:8a vsan 1
pwwn 21:01:00:e0:8b:2e:76:8a vsan 1
pwwn 21:00:00:e0:8b:0e:74:8a vsan 4
pwwn 21:01:00:e0:8b:2e:87:8a vsan 5
[Total 6 entries]
* is auto-learnt entry
switch9# show dpvm status
DB is activated successfully, auto-learn is off
Step 8 Access switch3 and issue the following commands.
switch3# show dpvm database active
pwwn 21:00:00:e0:8b:0e:76:8a vsan 1
pwwn 21:01:00:e0:8b:2e:76:8a vsan 1
pwwn 21:00:00:e0:8b:0e:87:8a vsan 1
pwwn 21:01:00:e0:8b:2e:74:8a vsan 1
pwwn 21:00:00:e0:8b:0e:74:8a vsan 4
pwwn 21:01:00:e0:8b:2e:87:8a vsan 5
[Total 6 entries]
* is auto-learnt entry
switch3# show dpvm status
DB is activated successfully, auto-learn is off
These basic steps help you ascertain that the information is identical in all the switches in the fabric.
Note
You have now configured a basic DPVM scenario in a Cisco MDS 9000 Family switch.
Default Settings
Table 17-1
Table 17-1
Parameters
DPVM
DPVM distribution
Autolearning
Cisco MDS 9000 Family Configuration Guide
17-12
lists the default settings for DPVM parameters.
Default DPVM Parameters
Default
Disabled.
Enabled.
Disabled.
Chapter 17 Creating Dynamic VSANs
OL-6973-03, Cisco MDS SAN-OS Release 2.x