Upgrading A Loader - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Mds 9000 family

Table of Contents

Software Images

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .

Ensure that the software images are not damaged or corrupted in the saved bootflash: file system.

When copying a new image to your switch, confirm that the image was not corrupted during the copy

Use the show version image command to verify that the required image was copied successfully.

switch# show version image bootflash:kickstart-image

image name: m9500-sf1ek9-kickstart-mzg.1.0.3.bin

Compare the running system image and the new image by issuing the show install all impact command.

Upgrading a Loader

The install module slot# of the supervisor module loader command upgrades the (boot) loader.

If the loader is upgraded, you need to reboot to make the new loader effective. You can schedule the

reboot at a convenient time so traffic is not impacted.

Before issuing this command, be sure to read the release notes to verify compatibility issues between the

loader and the kickstart or system images.

To upgrade the loader on either the active or standby supervisor module, follow these steps.

Use the show version command to verify the version on the active and standby supervisor modules.

switch# show version

Cisco Storage Area Networking Operating System (SAN-OS) Software

TAC support: http://www.cisco.com/tac

The copyrights to certain works contained herein are owned by

Cisco Systems, Inc. and/or other third parties and are used and

distributed under license. Some parts of this software are covered

under the GNU Public License. A copy of the license is available

at http://www.gnu.org/licenses/gpl.html.

kickstart: version 2.1(2)

BIOS compile time:

kickstart image file is: bootflash:///m9500-sf1ek9-kickstart-mz.2.1.2.bin

OL-6973-03, Cisco MDS SAN-OS Release 2.x

version 2.1(2)

version 1.0(3)

2/12/2003 11:00:00

A verification failed message is generated when you use a Cisco MDS 9500 Series image on a

Cisco MDS 9200 Series switch or a Cisco MDS 9200 Series image on a Cisco MDS 9500 Series

switch. Be sure to verify the right image.

version 1.0.8

version 1.1(2) <-------------------------current running version

version 2.1(2)

Manual Upgrade on a Dual Supervisor Switch

Cisco MDS 9000 Family Configuration Guide