Table of Contents
Advertisement
Chapter 36
Configuring IP Services
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Displaying IP Interface Information
Use the following show commands to view configured IP interface information (see Examples
36-4).
Example 36-1 Displays the VSAN Interface
switch# show interface vsan1
vsan1 is up, line protocol is up
Note
Example 36-2 Displays the Connected and Static Route Details
switch# show ip route
Codes: C - connected, S - static
Default gateway is 172.22.95.1
C 172.22.95.0/24 is directly connected, mgmt0
C 10.1.1.0/24 is directly connected, vsan1
Example 36-3 Displays Configured Routes
switch# show ip route configured
Destination
Example 36-4 Displays the IP Routing Status
switch# show ip routing
ip routing is disabled
OL-6973-03, Cisco MDS SAN-OS Release 2.x
WWPN is 10:00:00:05:30:00:59:1f, FCID is 0x9c0100
Internet address is 10.1.1.1/24
MTU 1500 bytes, BW 1000000 Kbit
0 packets input, 0 bytes, 0 errors, 0 multicast
0 packets output, 0 bytes, 0 errors, 0 dropped
You can see the output for this command only if you have previously configured a virtual
network interface (see the
Gateway
default
172.22.95.1
10.1.1.0
0.0.0.0
172.22.95.0
0.0.0.0
"Configuring an IP Address in a VSAN" section on page
Mask Metric
0.0.0.0
255.255.255.0
255.255.255.0
Cisco MDS 9000 Family Configuration Guide
Displaying IP Interface Information
Interface
0
mgmt0
0
vsan1
0
mgmt0
36-1
to
36-5).
36-11
Advertisement
Table of Contents
