Default Settings - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Chapter 33 Configuring FCIP
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Figure 33-14 PortChannels at the Fibre Channel and Ethernet Levels
Gigabit Ethenet link
To configure Fibre Channel PortChannels, see
Ethernet PortChannels, see the

Default Settings

Table 33-1
Table 33-1 Default FCIP Parameters
Parameters
TCP default port for FCIP
minimum-retransmit-time
keepalive-timeout
max-retransmissions
PMTU discovery
pmtu-enable reset-timeout
SACK
max-bandwidth
min-available-bandwidth
round-trip-time
Buffer size
Control TCP and data connection
TCP congestion window monitoring
Burst size
TCP connection mode
special-frame
FCIP timestamp
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Fibre Channel PortChannel
Fibre Channel
FCIP
TCP
IP
Ethernet
Ethernet PortChannel
Gigabit Ethenet link
"Configuring Gigabit Ethernet High Availability" section on page
lists the default settings for FCIP parameters.
Fibre Channel
FCIP
TCP
IP
Ethernet
Gigabit Ethenet link
Chapter 13, "Configuring PortChannels."
Default
3225.
200 ms.
60 seconds.
4 retransmissions.
Enabled.
3600 seconds.
Enabled.
1Gbps.
500 Mbps.
1 ms.
0 KB.
No packets are transmitted.
Enabled.
50KB.
Active mode is enabled.
Disabled.
Disabled.
Cisco MDS 9000 Family Configuration Guide
Default Settings
To configure
37-15.
33-33