Default Network Configuration - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Default Network Configuration

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Default Network Configuration
If you assign the IP default network address, the switch considers routes to that network as the last resort.
If the IP default network address is not available, the switch uses the IP default gateway address. For
every network configured with the IP default network address, the switch flags that route as a candidate
default route, if the route is available.
If you configure the static route IP forwarding and the default network details, these IP addresses will
Tip
be used regardless of the default gateway being enabled or disabled. If these IP address are configured
and not available, the switch will fall back to using the default gateway IP address, if you have configured
it. Be sure to configure IP addresses for all entries in the switch.
See the
for all entries in the switch.
When the Ethernet interface is configured, the switch should point to the gateway router for the IP
network. The host accesses the gateway using a gateway switch. This gateway switch is configured as
the default gateway. The other switches in the fabric that are connected to the same VSAN as the gateway
switch can also be connected through the gateway switch. Every interface connected to this VSAN
should be configured with the VSAN IP address of the gateway switch (see
Figure 36-2
1.1.1.10
Switch A
Switch D
In Figure
has the IP address 1.12.11.3, and switch D has the IP address 1.12.11.4. Switch A is the gateway switch
with the Ethernet connection. The NMS uses the IP address 1.1.1.10 to connect to the gateway switch.
Frames forwarded to any switch in the overlaid VSAN 1 are routed through the gateway switch.
Configuring the gateway switch's IP address, 1.12.11.1, in the other switches enable the gateway switch
to forward the frame to the intended destination. Similarly, if a non-gateway switch in the VSAN
forwards a frame to the Ethernet world, the frame is routed through the gateway switch.
When forwarding is disabled (default), IP frames are not sent from one interface to another. In these
cases, the software performs local IP routing between two switches using the in-band option for Fibre
Channel traffic and the mgmt0 option for Ethernet traffic.
When a VSAN is created, a VSAN interface is not created automatically. You need to specifically create
the interface (see the
Cisco MDS 9000 Family Configuration Guide
36-4
"Initial Setup Routine" section on page 4-2
Overlay VSAN Functionality
NMS
Ethernet connection
1.12.11.1
VSAN 1
1.12.11.1
1.12.11.4
36-2, switch A has the IP address 1.12.11.1, switch B has the IP address 1.12.11.2, switch C
"Configuring VSAN Interfaces" section on page
for more information on configuring the IP addresses
Switch B
1.12.11.2
1.12.11.1
Switch C
1.12.11.1
1.12.11.3
Chapter 36 Configuring IP Services
Figure 36-2).
11-22).
OL-6973-03, Cisco MDS SAN-OS Release 2.x