Table of Contents
Advertisement
Chapter 37
Configuring IP Storage
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Example 37-8 Displays Ethernet MAC Statistics
switch# show ips stats mac interface gigabitethernet 8/1
Ethernet MAC statistics for port GigabitEthernet8/1
Displaying DMA-Bridge Statistics
You can display direct memory access (DMA) device statistics using the show ips stats dma-bridge
interface gigabitethernet command. This command takes the main Gigabit Ethernet interface as a
parameter and returns DMA bridge statistics for that interface. See
Use the physical interface, not the subinterface, to display DMA-bridge statistics.
Note
Example 37-9 Displays DMA-Bridge Statistics
switch# show ips stats dma-bridge interface gigabitethernet 7/1
Dma-bridge ASIC Statistics for port GigabitEthernet7/1
This output shows all Fibre Channel frames that ingress or egress from the Gigabit Ethernet port.
Displaying TCP/IP Statistics
Use the show ips stats ip interface gigabitethernet to display and verify IP statistics. This command
takes the main Ethernet interface as a parameter and returns the IP statistics for that interface. See
Example
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Hardware Transmit Counters
237 frame 43564 bytes
0 collisions, 0 late collisions, 0 excess collisions
0 bad frames, 0 FCS error, 0 abort, 0 runt, 0 oversize
Hardware Receive Counters
427916 bytes, 3464 frames, 0 multicasts, 3275 broadcasts
0 bad, 0 runt, 0 CRC error, 0 length error
0 code error, 0 align error, 0 oversize error
Software Counters
3429 received frames, 237 transmit frames
0 frames soft queued, 0 current queue, 0 max queue
0 dropped, 0 low memory
Hardware Egress Counters
231117 Good, 0 bad protocol, 0 bad header cksum, 0 bad FC CRC
Hardware Ingress Counters
218255 Good, 0 protocol error, 0 header checksum error
0 FC CRC error, 0 iSCSI CRC error, 0 parity error
Software Egress Counters
231117 good frames, 0 bad header cksum, 0 bad FIFO SOP
0 parity error, 0 FC CRC error, 0 timestamp expired error
0 unregistered port index, 0 unknown internal type
0 RDL ok, 0 RDL drop (too big), 0 RDL ttl_1
3656368645 idle poll count, 0 loopback, 0 FCC PQ, 0 FCC EQ
Flow Control: 0 [0], 0 [1], 0 [2], 0 [3]
Software Ingress Counters
218255 Good frames, 0 header cksum error, 0 FC CRC error
0 iSCSI CRC error, 0 descriptor SOP error, 0 parity error
0 frames soft queued, 0 current Q, 0 max Q, 0 low memory
0 out of memory drop, 0 queue full drop
0 RDL ok, 0 RDL drop (too big)
Flow Control: 0 [0], 0 [1], 0 [2], 0 [3]
37-10.
Configuring Gigabit Ethernet Interfaces
Example
37-9.
Cisco MDS 9000 Family Configuration Guide
37-13
Advertisement
Table of Contents
