Default Settings - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Default Settings

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Display the DHCHAP configuration in the Fibre Channel Interface
Step 7
MDS-9216# show fcsp interface fc 1/6
fc1/6
Repeat these steps on the connecting MDS 9509 Switch.
Step 8
MDS-9509# show wwn switch
Switch WWN is 20:00:00:05:30:00:38:5e
MDS-9509(config)# fcsp enable
MDS-9509(config)# fcsp dhchap password rtp9509
MDS-9509(config)# fcsp dhchap devicename 20:00:00:05:30:00:54:de password rtp9216
MDS-9509(config)# interface fc 4/5
MDS-9509(config-if)# fcsp on
MDS-9509# show fcsp dhchap database
DHCHAP Local Password:
Other Devices' Passwords:
MDS-9509# show fcsp interface fc 4/5
Fc4/5
You have now enabled and configured DHCHAP authentication for the sample setup in Figure
Default Settings
Table 31-2
Table 31-2
Parameters
DHCHAP feature
DHCHAP hash algorithm
DHCHAP authentication mode
DHCHAP group default priority
exchange order
DHCHAP timeout value
Cisco MDS 9000 Family Configuration Guide
31-12
fcsp authentication mode:SEC_MODE_ON
Status:Successfully authenticated
Non-device specific password:upt9509
Password for device with WWN:20:00:00:05:30:00:54:de is upt9216
fcsp authentication mode:SEC_MODE_ON
Status:Successfully authenticated
lists the default settings for all fabric security features in any switch.
Default Fabric Security Settings
Chapter 31
Default
Disabled.
A priority list of MD5 followed by SHA-1 for DHCHAP
authentication.
Auto-passive.
0, 4, 1, 2, and 3 respectively.
30 seconds.
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Configuring FC-SP and DHCHAP