Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual page 273

Chapter 10 Managing Modules
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Configuring the ASM-SFN Image Boot Variable for VSFN
To configure the ASM-SFN image boot variable for VSFN on switches running Cisco MDS SAN-OS
Release 2.0(1b) through Release 2.1(1a), follow these steps:
Log into the switch through the console port, an SSH session, or a Telnet session.
Step 1
Step 2 Verify that the ASM or SSM is physically installed in the switch. If the module is not physically
installed, insert it into the desired slot. Issue a show module command to verify the status of the module.
switch# show module
Mod
---
4
5
6
...
Note the slot number for later reference.
Verify the Cisco MDS SAN-OS release running on the switch and the location and name of the
Step 3
ASM-SFN boot image on the switch following the procedure described in the
Boot Image" section on page
Configure the ASM-SFN image boot variable to specify the ASM-SFN image to use when the module
Step 4
reloads.
switch# config terminal
switch(config)# boot asm-sfn bootflash:m9000-ek9-asm-sfn-mz.2.1.1a.bin module 4
switch(config)# exit
Note
Issue the show boot command to display the current contents of the ASM-SFN image boot variable.
Step 5
switch# show boot
sup-1
kickstart variable = bootflash:/boot-2-0-1-9
system variable =
bootflash:/isan-2-0-1-9;bootflash:/isan-2-0-0-181b;bootflash:/isan-2-0-0-181b
sup-2
kickstart variable = bootflash:/boot-2-0-1-9
system variable =
bootflash:/isan-2-0-1-9;bootflash:/isan-2-0-0-181b;bootflash:/isan-2-0-0-181b
Module 4
asm-sfn variable = bootflash:/m9000-ek9-asm-sfn-mz.2.1.1a.bin
Step 6 Save the boot variable configuration so the new boot image is used when the switch reboots.
switch# copy running-config startup-config
Note
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Ports Module-Type
----- -------------------------------- ------------------ ------------
32 Advanced Services Module
0 Supervisor/Fabric-1
0 Supervisor/Fabric-1
10-30.
You can specify only one image for the ASM-SFN image boot variable per module.
If you do not save this configuration, it is lost on a switch reboot, and the ASM or SSM stays in
the power-down state if your switch is running Cisco MDS SAN-OS Release 2.1(1a) or earlier,
or comes up in Fibre Channel switching mode if your switch is running Cisco MDS SAN-OS
Release 2.1(2) or later. You must perform this procedure again to recover the ASM-SFN image
boot variable configuration.
Installing the ASM-SFN Boot Image for VSFN
Model Status
DS-X9032-SMV ok
DS-X9530-SF1-K9 active *
DS-X9530-SF1-K9 ha-standby
"Verifying the ASM-SFN
Cisco MDS 9000 Family Configuration Guide
10-33