Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual page 428

Example Configurations
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Enable CFS distribution.
Step 3
mds# config t
Enter configuration commands, one per line.
mds (config)# ivr distribution
mds (config)# exit
Manually configure the IVR VSAN-topology. In
Step 4
(MDS1 and MDS2) are members of VSANs 1 and 4. The other two switches (MDS3 and MDS4) are
members of VSANs 2, 3, and 4.
mds# conf t
Enter configuration commands, one per line.
mds(config)# ivr vsan-topology database
mds(config-ivr-topology-db)# autonomous-fabric-id 1 switch-wwn 20:00:00:05:40:01:1b:c2
vsan-ranges 1,4
mds(config-ivr-topology-db)# autonomous-fabric-id 1 switch-wwn 20:02:00:44:22:00:4a:08
vsan-ranges 1,4
mds(config-ivr-topology-db)# autonomous-fabric-id 1 switch-wwn 20:00:00:44:22:02:8a:04
vsan-ranges 2-4
mds(config-ivr-topology-db)# autonomous-fabric-id 1 switch-wwn 20:00:00:44:22:40:aa:16
vsan-ranges 2-4
mds(config-ivr-topology-db)# exit
Step 5 Verify the configured VSAN-topology.
Note
mds(config)# do show ivr vsan-topology
AFID
--------------------------------------------------------------
1
1
1
1
Total:
Current Status: Inter-VSAN topology is INACTIVE
Activate the configured VSAN topology.
Step 6
mds(config)# ivr vsan-topology activate
Verify the activation.
Step 7
mds(config)# do show ivr vsan-topology
AFID
--------------------------------------------------------------
1
1
1
1
Total:
Current Status: Inter-VSAN topology is ACTIVE
Last activation time: Tue May 20 23:14:59 1980
Cisco MDS 9000 Family Configuration Guide
18-32
The configured topology has not yet been activated—as indicated by the
the column.
Active
SWITCH WWN
20:00:00:05:40:01:1b:c2 *
20:00:00:44:22:00:4a:08
20:00:00:44:22:02:8a:04
20:00:00:44:22:40:aa:16
4 entries in active and configured IVR VSAN-Topology
SWITCH WWN
20:00:00:05:40:01:1b:c2 *
20:00:00:44:22:00:4a:08
20:00:00:44:22:02:8a:04
20:00:00:44:22:40:aa:16
4 entries in active and configured IVR VSAN-Topology
End with CNTL/Z.
Figure 18-1, two of the four IVR-enabled switches
End with CNTL/Z.
Active Cfg. VSANS
no yes 1,4
no yes 1,4
no yes 2-4
no yes 2-4
Active Cfg. VSANS
yes yes 1,4
yes yes 1,4
yes yes 2-4
yes yes 2-4
Chapter 18 Configuring Inter-VSAN Routing
status displayed in
no
OL-6973-03, Cisco MDS SAN-OS Release 2.x