Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual page 274

Managing ASMs, SSMs, and Supervisor Modules
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Ensure that no devices are connect to the ASM or SSM, reload the module to load the new boot image.
Step 7
switch# reload module 4
reloading module 4 ...
The reload command power cycles the ASM.
Caution
Step 8 Issue the show module command to verify the status of the ASM or SSM.
switch# show module
MMod
---
4
5
6
Mod
---
4
5
6
Mod
-------- -----------------------------
4
Mod
---
4
5
6
* this terminal session
Managing ASMs, SSMs, and Supervisor Modules
This section describes the considerations for replacing ASMs, SSMs, and supervisor modules and for
upgrading and downgrading Cisco MDS SAN-OS releases.
Considerations for Replacing ASMs, SSMs, and Supervisor Modules
If you replace an ASM, SSM, or supervisor module, you should consider the following:
•
•
•
Cisco MDS 9000 Family Configuration Guide
10-34
Reloading the ASM or SSM disrupts traffic through the module.
Ports Module-Type
----- -------------------------------- ------------------ ------------
32 Advanced Services Module
0 Supervisor/Fabric-1
0 Supervisor/Fabric-1
Sw Hw World-Wide-Name(s) (WWN)
----------- ------ --------------------------------------------------
2.1(2) 0.30 20:c1:00:05:30:00:06:de to 20:e0:00:05:30:00:06:de
2.1(2) 4.0 --
2.1(2) 4.0 --
Application Image Description
ASM-SFN linecard image
MAC-Address(es)
--------------------------------------
00-05-30-00-9e-b2 to 00-05-30-00-9e-b6
00-0e-38-c6-2c-6c to 00-0e-38-c6-2c-70
00-0f-34-94-4d-34 to 00-0f-34-94-4d-38
If you replace an ASM or SSM with another ASM or SSM and the boot image is on bootflash:,
respectively, you can leave the boot image installed on the active supervisor.
If you replace an SSM with another SSM and the SSI boot image is on the modflash:, the SSM might
not initialize. See the "Recovering an SSM After Replacing Corrupted CompactFlash Memory"
section on page 10-35.
If you replace an ASM or SSM with any other module, you can leave the boot image installed on
the active supervisor or remove it. The active supervisor module detects the module type and boots
the module appropriately.
Chapter 10
Model Status
DS-X9032-SMV ok
DS-X9530-SF1-K9 active *
DS-X9530-SF1-K9 ha-standby
Application Image Version
-------------------------
2.1(1a)
Serial-Num
----------
JAB06480590
JAB082504MQ
JAB083407D3
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Managing Modules