Table of Contents
Advertisement
Chapter 24
Configuring FICON
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Enter yes (the default is no) to set up FICON in cascaded mode. If you enter no, skip to
Step 7
"CUP In-Band Management"
Would you like to configure ficon in cascaded mode: (yes/no) [no]: yes
a.
b.
c.
Step 8
Enter yes (the default is yes) to deny SNMP permission to modify existing port connectivity parameters
(see the
Enable SNMP to modify port connectivity parameters? (yes/no) [yes]: yes
Enter no (the default is no) to disable the host (mainframe) to modify the port connectivity parameters,
Step 9
if required (see the
Disable Host from modifying port connectivity parameters? (yes/no) [no]: no
Step 10
Enter yes (the default is yes) to enable the active equals saved feature (see the
Automatic Save"
Enable active=saved? (yes/no) [yes]: yes
Step 11
Enter yes (the default is yes) if you wish to configure additional FICON VSANs.
Would you like to configure additional ficon vsans (yes/no) [yes]: yes
Review and edit the configuration that you have just entered.
Step 12
Enter no (the default is no) if you are satisfied with the configuration.
Step 13
Note
The following configuration will be applied:
fcdomain domain 2 static vsan 1
fcdomain restart disruptive vsan 1
fabric-binding database vsan 1
swwn 11:00:02:01:aa:bb:cc:00 domain 4
fabric-binding activate vsan 1
zone default-zone permit vsan 1
ficon vsan 1
no host port control
fcdomain domain 3 static vsan 2
fcdomain restart disruptive vsan 2
fabric-binding activate vsan 2 force
zone default-zone permit vsan 2
ficon vsan 2
no host port control
no active equals saved
OL-6973-03, Cisco MDS SAN-OS Release 2.x
section in this chapter).
Assign the peer WWN for the FICON: CUP.
Configure peer wwn (hh:hh:hh:hh:hh:hh:hh:hh): 11:00:02:01:aa:bb:cc:00
Assign the peer domain ID for the FICON: CUP
Configure peer domain (1-239) :4
Enter yes if you wish to configure additional peers (and repeat Steps
wish to configure additional peers.
Would you like to configure additional peers: (yes/no) [no]: no
"FICON SNMP Control"
"FICON Host Control"
section in this chapter.).
For documentation purposes, the following configuration displays three VSANs with different
FICON settings. These settings provide a sample output for different FICON scenarios.
section in this chapter).
section in this chapter.).
Cisco MDS 9000 Family Configuration Guide
Setting Up a Basic FICON Configuration
Step 8
7a
and 7b). Enter no, if you do
"Running Configuration
(see the
24-13
Advertisement
Table of Contents
