Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual page 246

Connecting to a Module
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
To attach to a module, follow these steps:
Command
Step 1
switch# attach module 6
switch(standby)#
Step 2
switch(standby)# dir bootflash:
root
admin
admin
root
root
admin
admin
root
admin
admin
You can also use the attach module command as follows:
•
•
Cisco MDS 9000 Family Configuration Guide
10-6
14502912 Jan 13 12:23:52 1980 kickstart_image1
14424576 Jan 14 06:47:29 1980 kickstart_image2
14469632 Jan 14 01:29:16 1980 kickstart_image3
14490112 Jan 08 07:25:50 1980 kickstart_image4
12288 Jan 16 15:49:24 1980 lost+found/
14466048 Jan 14 02:40:16 1980 kickstart_image5
24206675 Jan 14 02:57:03 1980 m9500-sf1ek.bin
19084510 Jan 13 12:23:28 1980 system_image1
19066505 Jan 14 06:45:16 1980 system_image2
18960567 Jan 14 01:25:21 1980 system_image5
Usage for bootflash: filesystem
158516224 bytes total used
102400 bytes free
167255040 bytes available
To display the standby supervisor module information, although you cannot configure the standby
supervisor module using this command.
To display the switching module portion of the Cisco MDS 9200 Series supervisor module which
resides in slot 1.
Chapter 10 Managing Modules
Purpose
Provides direct access to the
specified module (in this example,
the standby supervisor module is in
slot 6).
Provides the available space
information for the standby
supervisor module.
Note Type exit to exit the
module-specific prompt.
If you are not accessing the
Tip
switch from a console
terminal, this is the only
way to access the standby
supervisor module.
OL-6973-03, Cisco MDS SAN-OS Release 2.x