Call Home Enable Function; Call Home Configuration Distribution - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Call Home Enable Function

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
To enable message throttling in a Cisco MDS 9000 Family switch, follow these steps:
Command
Step 1
switch# config t
Step 2
switch(config)# callhome
switch(config-callhome)#
Step 3
switch(config-callhome)# no
duplicate-message throttle
switch(config-callhome)# duplicate-message
throttle
Call Home Enable Function
Once you have configured the contact information, you must enable the Call Home function.
The enable command is required for the Call Home function to start operating.
To enable the Call Home function, follow these steps:
Command
Step 1
switch# config t
Step 2
switch(config)# callhome
switch(config-callhome)#
Step 3
switch(config-callhome)# enable
callhome enabled successfully
switch(config-callhome)#
switch(config-callhome)# disable
switch(config-callhome)#

Call Home Configuration Distribution

You can enable fabric distribution for all Cisco MDS switches in the fabric. When you perform Call
Home configurations, and distribution is enabled, that configuration is distributed to all the switches in
the fabric.
The Switch priority and the Syscontact name are not distributed.
Note
You automatically acquire a fabric-wide lock when you issue the first configuration command after you
enabled distribution in a switch. The Call Home application uses the effective and pending database
model to store or commit the commands based on your configuration. When you commit the
configuration changes, the effective database is overwritten by the configuration changes in the pending
database and all the switches in the fabric receive the same configuration. After making the configuration
changes, you can choose to discard the changes by aborting the changes instead of committing them. In
either case, the lock is released. Refer to
on the CFS application.
Cisco MDS 9000 Family Configuration Guide
45-12
Purpose
Enters configuration mode.
Enters the Call Home submode.
Disables the duplicate message throttling feature.
Enables the duplicate message throttling feature
(default).
Purpose
Enters configuration mode.
Enters Call Home submode.
Enables the Call Home function.
Disables the Call Home function. When you disable the
Call Home function, all input events are ignored.
Note Even if Call Home is disabled, basic information
for each Call Home event is sent.
Chapter 5, "Using the CFS Infrastructure"
Chapter 45 Configuring Call Home
for more information
OL-6973-03, Cisco MDS SAN-OS Release 2.x